Customer matched zone "Locations not covered by your other zones"
“LUBE USA MMXL-III Automatic Intermittent Piston Pump” has been added to your cart.
View cart
LUBE USA AMO-II-150S Automatic Intermittent Gear Pump
$0.00
Automatic intermittent gear pump without
controller. Capable of working with a wide
range of oil viscosities.
DESCRIPTION:
Specifications
| Pump |
Discharge Volume |
150ml / min (50Hz) 180ml / min (60Hz) |
| Discharge Pressure |
2.0MPa (safety valve set pressure) |
| Motor |
Voltage / Current |
AC100Vφ1/0.83A AC200Vφ1/0.41A (50Hz)
AC100Vφ1/0.64A AC200Vφ1/0.33A (60Hz) |
| Output |
20W (50Hz/60Hz) CondesorMotor |
| Emergency Detection |
Oil level pressure |
| Oil level switch |
| Contact Type |
A Contact (NO) ON at low level |
| Contact capacity |
0.5A AC DC200V/30W smaller |
|
| Prerssure switch |
| Contact Type |
A Contact (NO)
Operating pressure:1.7MPa OFF
Reset pressure: 0.9MPa ON |
| Contact capacity |
AC DC250V/3A |
|
| Operation Rating |
Max. Discharge time:99sec
Min. Interval time:1min |
| Working Viscosity Range |
68〜1000mm2/S (50Hz) |
| Reservoir Capacity |
1.8ℓ、3ℓ (plastic) 3ℓ、4ℓ、8ℓ (sheet metal) |
| Weight |
1.8ℓReservoir：3.3kg 3ℓReservoir：4kg(plastic) |
APPLICATION:
Model
| Model |
Part Number |
| AMO-II-150S-1 |
202067 |
| AMO-II-150S-1-3 |
202069 |
| AMO-II-150S-1-P |
202071 |
| AMO-II-150S-1-P-3 |
202073 |
|
| Model |
Part Number |
| AMO-II-150S-2 |
202068 |
| AMO-II-150S-2-3 |
202070 |
| AMO-II-150S-2-P |
202072 |
| AMO-II-150S-2-P-3 |
202074 |
|
Directions for use
| ● |
This pump unit requires a separate control circuit to operate. |
| ● |
Do not remove the oil strainer to keep the pump clear of foreign matter. |
| ● |
Replace or clean the suction filter at least once a year. Click here to view the service list. |
| ● |
Oil viscosity varies with oil temperature. Be sure to use oil within the working viscosity range. Refer to the viscosity table. |
| ● |
Do not use any special additive-contained oil, water soluble oil and solvent. |
| ● |
Periodically check the oil in the reservoir for impurities. Replace it, if necessary, with fresh oil immediately. Be sure to clean the reservoir before oil change. |
| ● |
Make sure that proper voltage and pressure are proper. |
| ● |
Do not overtighten the discharge joint. Refer to the tightening torque table. |
| ● |
Low-oil viscosity versions are available. Contact us for information. |
| ● |
For system planning information, Contact us. |
Document
Pump Drawing
Wiring digram
Dimensional Drawing
 |
Improper handling can result in a death or serious injury. |
|
 |
Electrical shock may be received under certain conditions.。 |
|
 |
Be sure to ground. |
