|
Servo Turbo Drive
|
|
Electronic limits
with no external switches to mount.
|
|
Low maintenance
brushless DC variable reluctance (VR) motor.
|
|
Peak Torque is
200 in-lb/22.6 N-m
|
|
Lift heavy knees
such as the Bridgeport Series II or Lagun Deluxe.
|
|
Set a zero position and
use the digital display for rough positioning (0.1" resolution).
|
|
Rapid for table and
cross is 80 inches per minute (ipm).
|
|
Feed rate ramps from
0 to 50 ipm in 4 increments.
|
|
Digital feed rate
control lets you select exact feed rates (0.1 ipm resolution).
|
|
Smooth finish at
feeds as low as 0.2 ipm.
|
|
Electronic-assist when
used with muscle power.
|
|
Fluid-resistant
design.
|
|
|
Type 140 "Workhorse" Power Feed
|
|
Semi-automated machining on
Class 1 mills to 3 hp.
|
|
Peak Torque (half-wave
series motor): to 140 in-lb/15.8 N-m.
|
|
Intermittent Torque:
105 in-lb/11.9 N-m.
|
|
Continuous Torque: 90
in-lb/10.2 N-m
|
|
Variable Feed Rate:
.75-25 ipm or 19-635mm/min. (table/cross); 0-12 ipm or 0-305mm/min. (knee).
|
|
Rapid Traverse: 35 ipm
or 889 mm/min. (table/cross); 12 ipm or 305 mm/min. (knee).
|
|
Gear Reduction Ratio
(motor to lead screw shaft): 72:1.
|
|
Helical gearing and torque
limiting friction safety clutch.
|
|
Electrical: 110V,
50/60 Hz, 2.5A.
|
|
Approx. weight: 15
lb./6.8 kg.
|
|
|
Type 150 Power Feed
|
|
Semi-automated machining
on Class 1 mills to 3 hp.
|
|
Peak Torque
(full-wave SCR control compound DC motor): to 150 in-lb/17 N-m.
|
|
Intermittent Torque
: 120 in-lb/13.6 N-m.
|
|
Continuous Torque:
100 in-lb/11.3 N-m.
|
|
Variable Feed Rate:
.50-35 ipm/13-889 mm/min.
|
|
Rapid Traverse:
35 ipm/889 mm/min.
|
|
Gear Reduction Ratio:
72:1.
|
|
Smooth surface finish at
speeds as low as .5 ipm or 13 mm/min. at full torque.
|
|
Electrical:
110V, 50/60 Hz, 3A.
|
|
Approx. weight:
15 lb./6.8 kg.
|
|
Superior speed regulation,
ramping, dynamic breaking, friction safety clutch and limiting circuit protection.
|
|
